Products required: A disinfectant product suitable for your pool.
See table options below:
Choice of disinfectant product
| Pool volume | Recommended disinfectant product | Dosage |
| 3,000-5,000 litres |
Pool Power Mini Quick, fast-dissolving disinfectant tablets, suited for continuous disinfection |
Never add directly to the pool! First, dissolve the tablets in a glass of water and then distribute the solution evenly across the water surface. The Mini-Quick tablets can also be added using a dosage float. |
| 5,000-30,000 litres |
Pools with filtration systems: |
Add the required number of tablets through the skimmer: 1 tablet per 2,500 litres |
| >30,000 litres | 200 grams of Pool Power Long, slow-dissolving disinfectant tablets will ensure continuous disinfection. | Add the required number of tablets through the skimmer: 1 tablet per 25,000 litres. |
Besides the disinfectant product selected, you will still need the following products:
Pool Power Choc – to apply a shock treatment (see application sequence below)
Pool Power pH min/pH plus – to lower or increase the pH value of the swimming pool water
Testkit or test strips for measuring active chlorine and the pH value
Pool Power Anti-algue – to control and avoid algae formation
Pool Power Floc or Super Cubes – without other agents, swimming pool filters will not remove all dirt. Small particles of dirt will inevitably escape the filter, causing the water to cloud.
Pool Power Gel – to clean the pool edges at water line.
Application sequence:
1. Measure the pH value of your pool water using a test kit and correct where necessary by adding pH min or pH plus. The pH value should be between 7.2 and 7.6. When pH values are too high or too low, the water can cause irritation to the eyes or skin.2. Add the selected disinfectant according to the instructions on the label.
3. Give your swimming pool a shock treatment at the start of the season and thereafter, every 14 days. A shock treatment consists of a dosage of chlorine three times higher than normal. The shock treatment will destroy and oxidize accumulated organic substances. In this way, you can also prevent formation of so-called chloramines. Chloramines cause an annoying ‘chlorine odour’. This means that there is too little, not too much, chlorine in the water. Check the pH value and chlorine percentage regularly, using a test kit.
4. Weekly dosage of Pool Power Anti-algae.
5. Use (liquid) Pool Power FLOC, Solufloc (cartouche) or Super Cubes (flocculation is active over a longer period) to remove any dirt particles from the bottom or floating in the water.
Safety:
Although instructions for using our Pool Power products are clearly stated on the labels, we would like to draw attention to the following points!· Store swimming pool products in a dry, cool area beyond the reach of children.
· Avoid direct contact between the disinfectant products and the plastic lining of your swimming pool.
· Always use and add the products separately. Do NOT mix them!
· Always add the products to the water, not the other way around.
· Read the instructions on the labels carefully.
· Never use empty packages of disinfectant products to store other items.
· If you are using a dosage device, make sure that it is suitable for the disinfectant products you purchase. Improper usage could cause an explosion.
· Only use water to extinguish fires. Do not use a powder fire extinguisher.
· Close the product packages after use.
